Assembly Outputs
Supported Assembly Outputs
The following assembly-type outputs can be generated in Altium Designer:
- Assembly Drawings
- Pick and Place Files
- Assembly Testpoint Reports
Configuring Assembly Output Generators
The Assembly Outputs category in the OutputJob Editor allows you add and configure any of the output types listed above. The configuration dialog for each output type can be accessed in one of the following ways:
- Selecting the required Output Generator and choosing the Configure command from the Edit menu
- Right-clicking on the required Output Generator and choosing the Configure command from the pop-up menu that appears
- Selecting the required Output Generator and using the keyboard shortcut, Alt + Enter
- Double-clicking directly within the row for the required Output Generator.
Output generator configurations are in the OutJob file. Clicking OK in a configuration dialog saves that configuration, but does not proceed with output generation. Generation of output is performed by running the OutputJob Output Container that those Outputs are targetting.
Configuring each Assembly Output Type
For more information about configuring and generating the various output types, use the links below:
Assembly Drawings, see PCB Printout Output Options
Pick and Place files, see Pick and Place Setup
Assembly Test Point Reports, see Test Point Report Setup
Assembly Variants
Assembly Drawings and Pick and Place files can be configured to use Assembly Variants.
See True Variants for more information.