Documentation Outputs
The Documentation Outputs category of the OutputJob Editor allows you to create the following Output Generators:
- Composite Drawing
- Logic Analyzer Prints
- OpenBus Prints
- PCB 3D Prints
- PCB Prints
- Schematic Prints
- SimView Prints
- Wave Prints (Wave Editor)
- WaveSim Prints (WaveSim Editor)
Configuring Documentation Output Generators
Depending on the specific output type, options may be available for you to configure the associated output generator, providing more control over the generated output. Where configuration options are available, they can be accessed in one of the following ways:
- Selecting the required Output Generator and choosing the Configure command from the Edit menu
- Right-clicking on the required Output Generator and choosing the Configure command from the pop-up menu that appears
- Selecting the required Output Generator and using the keyboard shortcut, Alt + Enter
- Double-clicking directly within the row for the required Output Generator.
After configuring output generators in associated configuration dialogs, definitions are saved in the OutJob file. Clicking OK in a setup dialog commits the configuration but does not proceed with generation. Generation of output is performed using the Output Media functionality.
If multiple output generators are selected, the configuration dialog will appear for the output generator that was selected last.
Different output generators have unique dialogs to configure precisely what gets generated when the output is run.
For more information about configuring your Composite PCB Print, PCB Prints and PCB 3D Prints, see PCB Printout Output Options
For more information about configuring your SimView Prints, Wave Prints and WaveSIM see Waveform Analysis in Altium Designer
Assembly Variants
Schematic Prints can be configured to use Assembly Variants. See Generating Output for an Assembly Variant for more information
Links to other Outputs
Assembly Outputs
Fabrication Outputs
Netlist Outputs
Report Outputs