Report Outputs
The Report Outputs category of the OutputJob Editor allows you to create the following Output Generators:
- Bill of Materials
- Component Cross Reference
- Report Project Hierarchy
- Simple BOM
- Report Single Pin Nets
Configuring Report Output Generators
Depending on the specific output type, options may be available for you to configure the associated output generator, providing more control over the generated output. Where configuration options are available, they can be accessed in one of the following ways:
- Selecting the required Output Generator and choosing the Configure command from the Edit menu
- Right-clicking on the required Output Generator and choosing the Configure command from the pop-up menu that appears
- Selecting the required Output Generator and using the keyboard shortcut, Alt + Enter
- Double-clicking directly within the row for the required Output Generator.
If multiple output generators are selected, the configuration dialog will appear for the output generator that was selected last.
Different output generators have unique dialogs to configure precisely what gets generated when the output is run.
Generating Reports directly from the Project
Report Output can also be generated directly from your project using the Reports menu. Note that the options available in the Reports menu change depending on your active editor (PCB, Schematic..)
For more information about configuring your Bill of Materials and Component Cross Reference Report see Generating a Custom Bill of Materials.
Assembly Variants
The following Report Outputs can be configured to use Assembly Variants:
- Bill of Materials
- Component Cross Reference Report
- Report Project Hierarchy
- Report Single Pin Nets
- Simple BOM
See Generating Output for an Assembly Variant for more information