Import FPGA Changes Wizard - Choosing the Configurations to use

Frozen Content

Modified by Admin on Sep 13, 2017

If there are multiple compatible configurations in the Stub and/or Master FPGA projects, the next page in the Import FPGA Project Changes Wizard will allow you to choose which configuration to use in each project.

Figure 1. Specify which configuration to use for the Stub and Master projects, where multiple configurations exist.

A configuration will be compatible if it contains a constraint file targeting the physical FPGA device in the FPGA project. Simply choose the configuration that is to be used for both Stub and Master.

The configuration chosen should be the one which contains the relevant constraint file that:

Contains the design changes synchronized from the PCB project, in the case of the Stub and

Is required to take the imported design changes, in the case of the Master.

Note: If there is only one configuration in both the Stub and Master projects, this page of the Wizard will not be displayed.

Note: It is possible that the same constraint file is used in multiple configurations. Although only one compatible configuration would be chosen, all configurations are effectively 'chosen' in this case, although only one constraint file will be updated.