Duplicate Nets

This compiler hint appears when two nets with the same name have been detected within the design. The message is displayed in the Messages panel in the following format:

Duplicate Net Names Object NetName,

where

Object is either Wire or Bus Slice or Element[n] (for a bus element)

NetName is the name of the affected net.

Default Report Mode

Error

Recommendation

This violation can arise when, for example:

• The design is hierarchical, with separate sheet symbols used to reference distinct child sheets, and sheet entries connecting to ports on those child sheets. The Net Identifier Scope is automatically (or manually) set to Hierarchical (Sheet entry <-> port connections). The violation will occur if the same net label has been used on both child sheets. This is because net labels defined on each sub-sheet, even with the same name, remain local to those sub-sheets. The resolution in this case is to ensure unique net labeling is used between sheets.
• The design is flat and ports have been used within the design. The Net Identifier Scope is automatically (or manually) set to Flat (Only ports global). The violation will occur if the same net label has been used between sheets. This is because net labels defined on each sheet, even with the same name, remain local to those sheets. The resolution in this case is to ensure unique net labeling is used between sheets.
• The net continuity between flattened schematic sheets is broken by the inadvertent use of ports or offsheet connectors with different names. Use the Compile Errors dialog to quickly cross probe to the duplicate net naming. Trace the net back to the incoming/outgoing port on each sheet and ensure the names for the ports are made the same.
• You may have the same net used in two different branches of a hierarchical design - i.e. different sheet symbols are used to reference different child sheets, but the same name is used for the top-level sheet entries and descendent ports, and the two symbols are connected by a physical wire or bus. The net continuity between these branches can be broken by the inadvertent use of sheet entries with different names or the omission of a physical bus/wire connecting the sheet entries. Ensure that the physical wire connecting the two sheet symbols is in place and wired correctly and that the sheet entries are named the same.