Drill-Pair Manager

Old Content - visit altium.com/documentation

Parent page: PCB Dialogs

The Drill Pair Manager Dialog.

Summary

This dialog allows the designer to define drill pairs.

Access

In Layer Stack Manager dialog (Design >> Layer Stack Manager), click button Configure Drill Pairs to access this dialog, or, right click the PCB Editor, choose and run command Options » Drill Pairs... from the popup menu.

Options/Controls

  • Start Layer - The start layer of a drill pair.
  • Stop Layer - The stop layer of a drill pair.
  • Add - Click to add a new drill pair.
  • Delete - Click to delete the selected drill pair.
  • Drill Pair Properties - Click to open Drill Pair Properties dialog.
  • Create Pairs From Layer Stack - Click to remove all drill pairs and replace with layer stack pairs. A dialog will appear to confirm the operation.
  • Create Pairs From Used Vias - Click to create drill pairs used by vias/pads. A dialog will appear to confirm the operation.
  • Menu - Click to show the same button entries as listed in the bottom of the dialog.

 

You are reporting an issue with the following selected text and/or image within the active document: