Un Route Single Room

Parent process: PCB:UnRoute

Applied parameters: Object = SingleRoom|ContextObject=Room

Summary

This command enables you to unroute all physical connections associated with the room under the cursor.

After launching the command, a dialog will appear, asking whether you wish to unroute connections that extend outside of the room. If you click Yes, all track that resides in or passes into/out of the room will be removed and replaced by the logical connections. If you click No, only the pad-to-pad connections that are contained wholly inside the room will be unrouted.

Availability

In PCB Editor, make sure that the room to be unrouted is selected and then right click the mouse over the room to open the menu and run command Room Actions » Unroute Room.

Notes

Where track passes outside of the boundaries of the room, the track is unrouted from a component pad in the room to the next destination pad along the track, outside of the room. Track on the other side of this destination pad will remain routed.

If any track is locked a confirmation dialog will appear, asking whether you want to allow the unroute for locked primitives. If you select No, then only track that is not locked will be unrouted.