The following content has been imported from Legacy Help systems and is in the process of being checked for accuracy.
Parent process: CAMtastic:InfoLoadDRCRulesFromPCB
Applied parameters: None
Summary
This command is used to load design rule constraint tolerances, where applicable, from the PCB design document into the
PCB Design Check/Fix dialog of the current CAMtastic document.
Details
After launching the command, the relevant design rule tolerances from the PCB document will be loaded into the
Size (mils) column of the
PCB Design Check/Fix dialog. The mapping of PCB design rule types to the corresponding DRC entries in the
PCB Design Check/Fix dialog, are as follows:
Min. Annular Ring (Drill->Pad)...................Minimum Annular Ring
Min. Annular Ring (Pad->Mask)................Solder Mask Expansion
Min. Clearance (Pad->Pad).......................Clearance
Min. Clearance (Pad->Trace)....................Clearance
Min. Clearance (Trace->Trace).................Clearance
Min. Trace Width........................................Width
Notes
If the current CAM document was generated from the Design Explorer-based PCB Editor, then after launching this command, the PCB document will be opened (if not already) and made the active document in the main design window.