Search
Search results
-
Navigator
... enabled. For each signal in the list, the node pins, sheet entries or cross-sheet connectors associated with that signal ... for that object type has been enabled or not. If a node pin associated with a signal is an output pin or an IO pin, then it is ...
admin - 12/18/2013 - 09:56
-
Analyses Setup
... time. The following options are available: Node Voltage and Supply Current - saves data for the voltage at each node and the current in each supply. Node Voltage, Supply and Device ...
phil.loughhead@... - 02/13/2014 - 07:16
-
Pole-Zero Analysis
... in the image below: Parameters Input Node - the positive input node for the circuit. Input Reference Node - the reference node for ...
phil.loughhead@... - 03/04/2014 - 00:51
-
Pole-Zero Analysis
... in the image below: Parameters Input Node - the positive input node for the circuit. Input Reference Node - the reference node for ...
admin - 09/13/2017 - 15:32
-
Noise Analysis
... Noise The noise measured at a specified output node. Input Noise The amount of noise that, if ... contribution of each component in the circuit. Output Node - the node in the circuit at which the total output noise is to be ...
phil.loughhead@... - 03/04/2014 - 00:51
-
Noise Analysis
... Noise The noise measured at a specified output node. Input Noise The amount of noise that, if ... contribution of each component in the circuit. Output Node - the node in the circuit at which the total output noise is to be ...
admin - 09/13/2017 - 15:32
-
Project Options - Connection Matrix
Parent page: WorkspaceManager Dialogs The Connection Matrix tab of the Project Options dialog. Summary The Connection Matrix tab of the Project Options dialog enables you to define the reporting leve...
admin - 09/13/2017 - 15:32
-
Transfer Function Analysis
... DC output resistance and DC gain, at each voltage node in the circuit. Setup Transfer Function analysis is set up on ... the input reference for the calculations. Reference Node - the node in the circuit used as a reference for the calculations at ...
phil.loughhead@... - 03/04/2014 - 00:51
-
Transfer Function Analysis
... DC output resistance and DC gain, at each voltage node in the circuit. Setup Transfer Function analysis is set up on ... the input reference for the calculations. Reference Node - the node in the circuit used as a reference for the calculations at ...
admin - 09/13/2017 - 15:32
-
Simulation Troubleshooting
... for the non-linearities. SPICE makes an initial guess at the node voltages then calculates the branch currents based on the conductances in ... SPICE then uses the branch currents to recalculate the node voltages, and the cycle is repeated. This cycle continues until all of the ...
phil.loughhead@... - 02/12/2014 - 06:18