OpenBus System - Configuring Arbiter Components
Frozen Content
Configuration of an Arbiter component is performed using the Configure OpenBus Arbiter dialog (Figure 1).
Figure 1. Configuring an Arbiter component.
In comparison to its schematic counterpart – WB_MULTIMASTER – configuration of the Arbiter is greatly streamlined. The OpenBus System once again handles much of the configuration for you, so information such as data and address bus widths no longer require user-definition.
Only two pieces of information are required through the dialog to configure the Arbiter – the mode in which the masters access the shared slave(s), and which master will be granted immediate access to the slave(s) when the Arbiter is in an "Idle" state. These are the access Type and the Master With No Delay, respectively.